Form to customize your heat exchange system

Request For Heat Exchanger Quote

Instructions for requesting a quotation:

Select a Cooling System you are interested in.
Complete the items shown on the sizing sheet.
This will enable Duramax Marine to determine the correct Cooler for your application.
Be sure to mark units (Metric/Imperial) where applicable.
Please provide as much of this information as possible.

Select a Cooling System you are interested in:
DuraCooler	SuprStak
Demountable	BoxCooler

PLEASE REVIEW ALL FORM FIELDS BEFORE SUBMIT

SENDING

PLEASE WAIT

DuraCooler^® is a registered trademark of Duramax Marine^® LLC.
SuprStak™ is a trademark of Duramax Marine^® LLC.

GENERAL INFORMATION
Company Name:
*Contact Name:
*Email:
Address:
City:
State:
Zip:
Country:
Phone:
Fax:
*Message:
Vessel Name/Hull #:
New Construction:	Yes No/Retrofit
Type/Use of Vessel:
Dimensions:	length beam draft feet meters
Hull Material:
Plumbing Options:	Same End Opposite Ends

EXTERNAL CONDITIONS
Minimum Vessel Speed at Full Power :	knots
Maximum Ambient Sea Water Temp:	°F °C
Location of Coolers:	Bottom Side of Hull
Are there space restrictions on the hull?	Yes No
If "Yes", list size restrictions:

MAIN ENGINE INFORMATION
Manufacturer:
Model Number:
Quantity:
Min. Speed at which full Power will be developed:	Knots
IMO / Tier:
Engine Power:	HP KW
Engine RPM:
Coolant Description	Brand Type % Mix
Cooling Circuits: (Check all that apply)	Jacket Water Circuit (HT) Aftercooler Circuit (LT) Jacket Water Aftercooler Combined Circuit (HT + LT) Other
High Temp. Cooling Circuit (Jacket Water): Coolant Temp from Engine to Cooler (Ta)	°F °C
Total Heat Rejection:	BTU/min KW
Pump Flow Rate/Range:	Flow Rate To Cooler GPM LPM m³/hr
Low Temp. Cooling Circuit (Aftercooler): Coolant Temp. from Cooler to Engine (Tb)	°F °C
Total Heat Rejection:	BTU/min KW
Pump Flow Rate/Range:	Flow Rate To Cooler GPM LPM m³/hr
Gear:	Yes No
Manufacturer of Gear (if cooled by DuraCooler):
If Reintjes gear, provide water pump flow:	GPM LPM m³/hr
System pressure drop requirements:
Attachment Method to Hull:	Pipe Flange (outside hull) Through-hull Nozzle (may require cofferdam)

GENERATOR
Manufacturer:
Model Number:
Quantity:
IMO / Tier:
Engine Power:	HP KW
Engine RPM:
System pressure drop requirements: (will be sized for 0 knots unless otherwise directed.)

OTHER (Pump, Thruster, Compressor, etc.)
Type:
Manufacturer:
Model Number:
Quantity:
IMO / Tier:
Engine Power:	HP KW
Engine RPM:
System pressure drop requirements: (will be sized for 0 knots unless otherwise directed.)